![]() ![]() Although the order is different, the steps to update OME-M and network IOMs remain the same. Note: The update order for versions prior to OME-M 2.00.00 recommended an order of servers, followed by OME-M, and then network IOMs. In the sections below, the instructions will provide additional information when updating multichassis or using different IOM operating modes. The following image shows the update order for all deployment types. After updating the Networking IOMs, please refer to the MX7000 Chassis User Guide linked above for server update instructions. This blog will follow the phased update order process. Note: If updating to a version prior to OME-M 2.00.00 or updating from a version prior to OME-M 1.40.00, use the update process documented in the section titled Updating firmware for PowerEdge MX solution in the appropriate Dell OpenManage Enterprise – Modular Edition PowerEdge MX7000 Chassis User’s Guide. The new process, called phased update order, is supported for upgrading from OME-M 1.40.xx to OME-M 2.00.00 and later. Starting with OME-M 2.00.00, a new recommended order for updating the MX chassis and all its components has been documented in Appendix B of the Dell OpenManage Enterprise – Modular Edition Version 2.00.00 for PowerEdge MX7000 Chassis User’s Guide. ![]() This blog will go through all the necessary steps to update both the Dell OME-Modular application and the networking IOMs for all types of deployments. If you are reading this blog, most likely your interest is in how to update the firmware on the Dell Networking MX I/O modules (IOMs). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |